Garage Doors Not Closing All The Way Down? Here Are 4 Possible Reasons

Garage doors are meant to offer security. But what if it doesn’t work as intended? Garage door repairs are not always noticed and fixed easily. It requires the trained eye of a professional who can look into the problem and provide the right solution to resolve the same. Sometimes, you will encounter a problem that the garage door might not be closing completely. If you are left clueless about it, here are some reasons highlighted by professionals of garage door repair in Boise, as to why the garage door doesn’t close all the way down:

  1. Problem With The Safety Sensor:

One of the most common problems for the malfunction of garage doors is an erroneous safety sensor. Safety sensors are usually located at the bottom of the garage door that senses and analyzes if there is anything on its way of closing the garage door. If one or both the sensors don’t have sufficient power to operate or do not emit the signal as required, the garage door might not close completely. These sensors are useful to make sure that there is nothing that blocks the door from its normal operation. Replacing the safety sensors is the solution to it.

  1. Springs Might Be Broken:

Garage door has multiple set of rings that facilitate its opening and closing operation. If one or more of these springs are broken or damaged, your garage door might end up not closing completely as required. If any spring is subject to more wear, that could also be a reason for the garage door to close partially. A quick inspection by a Boise garage door repair expert will help you to know if the spring is damaged. A professional will be able to identify the problem almost instantly.

  1. Misalignment Of The Sensor:

This doesn’t mean that the sensor is malfunctioned, but that it doesn’t work perfectly. If the twin sensors that are placed at the bottom of the garage door are out of alignment, your garage door might not close completely. You can easily find if the sensors are in alignment, with the help of a light built into it. If the light is on and stable, it means the sensors are in proper alignment. And if the light is blinking, it means they are misaligned. This problem can be resolved by properly aligning the sensors with the help of a professional.

  1. Cables Might Be Damaged:

Cables might be necessary depending on the type of garage door opener used. Cables complete the lowering action, so if they are damaged, this might not be achieved. Cable damages cannot be easily noticed, so have your garage door visually inspected by an expert to find any damage to the cable.

Fixing garage door problems on your own isn’t going to cut it. Even if you do, it might eventually lead to expensive repairs down the road. If you notice that your garage door isn’t closing completely, contact a garage door repair professional specialized in repair and garage door installation in Boise to identify the underlying problem.

 

Leave a Reply

Your email address will not be published. Required fields are marked *

*